Longworth Style Chuck 14" dia Bowl Remounting Jaws ref LSC14

Longworth Style Chuck LSC14
14" Self Centre Chuck for Remounting Bowls
 

Re-chucking bowls and patters for finishing or light shaping has always been something woodturners want to solve. The longworth style chuck makes it easy. This self-centering scroll operation quickly adjusts to fit the work and tightening only takes a few seconds. Designed for clamping in a traditiona 4 jaw-self-centering chuck using standard 50mm dovetail jaws. It eliminates the time and hasse of removing and remounting chuck jaws needed when using regular re-chucking jaws. Non-Marking premium silicone grippers provide pliable yet firm gripping power Precision cut, plates provide ultimate performance and reliability 600 RPM maximum. Chuck size indicates the minimum lathe swing for which it is intended Maximum external gripping capacity is approximately 2" smaller than chuck diameter.

Just rotate the plates of the Longworth Style Chuck and the soft silicone buttons close in almost instantly, and with perfect concentricity, to hold your project while you make the finishing cuts to the bottom side. Unlike many other rechucking methods, the silicone buttons won't mar your project or your finish. When compressed with the wing nuts, they expand to provide a secure grip. The 1/4" thick phenolic plates provide strength and stability, regardless of humidity. Available in two sizes: the 10" Longworth Style Chuck for mini and midi lathes with a 10" swing, and the 16" Longworth Style Chuck for standard-sized lathes with a 16" swing or larger.

Pick up a piece of fine china, and the first thing you'll do after admiring the face is turn it over to inspect the bottom and insignia. It's no different with turned bowls, and turners work hard to make the bottom as beautiful as the top. But chucking a finished bowl face down on the lathe without damaging it has always been a challenge - not with the Longworth Style Chuck. Simply rotate the plates, tighten down the buttons, and you're ready to turn.

• Eliminates the time and inconvenience of installing, adjusting and readjusting ordinary rechucking jaws.
• Capable of holding projects in compression or expansion mode (from the inside or outside of the rim of your turning project).
• Buttons close in concentrically, making it easy to center your project.
• Soft silicone buttons have increased length for better grip and expansion capabilities.
• Buttons expand when the wing nut is tightened, and will not mark or deform your turned piece.
• Includes 8 buttons. Replacement packs of buttons with hardware are available separately (#47455).
• No assembly required.
• 1/4" phenolic discs are extremely durable, stable, and spin in opposing directions with almost no resistance.
• The back side of the Longworth Style Chuck has a steel disk approximately 3/8" thick for mounting.
• The disk is easily gripped by any brand of 4-jaw scroll chuck with the standard 50mm #2 jaws.
• Straight jaws may be used, but dovetail jaws provide a better hold.
• The dovetail groove accommodates Nova chucks and Vicmarc chucks as well as OneWay type straight jaws.
• Recommended maximum RPM is 600.
• Intended for light finishing cuts only. Note for heavy stock removal.
• Note: Best practice for safety dictates that you engage the tailstock whenever possible. Remove the tailstock only when finishing the last bit in the very center, and for finish sanding.

The product you are currently viewing is highlighted in red.

Click here to see the full range of options for this product